Areas / Belconnen / Bruce

Bruce flood map & planning overlays

Canberra's Bruce is young, median 29, with 53 heritage places.

A planning-constraint profile of Bruce (Belconnen, ACT) - 6.61 km², mapped from live district and state overlay data. This suburb is highly constrained.
Profile updated 14 November 2026.

Elevation hillshade with street names, clipped to Bruce's boundary, with the flood, bushfire and environmental overlays drawn on top. Magenta is where aircraft were observed in the sampled period, brightest below 3,000 ft.

Nearby suburbs, nearest first

Aircraft noise and flight paths over Bruce

The ANEF contour is a published planning forecast and observed overflight is what a sampled tracking feed recorded - neither describes any individual property.

Observed overflight - sampled 4 Sep to 14 Nov 2026

Under observed aircraft
100%
of the suburb, at or below 10,000 ft
Below 3,000 ft
4%
of the suburb's area
Lowest measured
2,500 ft
averaging 4,500 ft
Busiest square
~2 a day
±27%
typical observed square 1 a day

Night movements: observed, lowest 3,500 ft - night is sampled as often as day, but night traffic is light, so this is a floor and no rate can be put on it.

How this is measured

Traffic is sampled rather than watched continuously, so every figure is a floor: aircraft not captured between samples are not represented. Rates are per 500 m square - the busiest square in the suburb, not a count of flights over the suburb - and a square is only rated where enough traffic was seen to measure it. Altitudes are above mean sea level. Flight paths change with runway use, weather, season and airspace design. This is a record of observed traffic; it is not a noise contour and not a planning control.

Bruce at a glance

Parcels 713 Median lot 524 m² Mapped easements 505 Bus stops 36

How Bruce is zoned

Community Facilities 28%
Designated 26%
Hills, Ridges and Buffer Areas 12%
Transport 8%
Urban Residential 7%
Mixed Use 5%

Buying in Bruce? The Territory Plan zone on this page sits alongside the Crown lease, which sets what a block may actually be used for.

Across its 6.61 km², Bruce is highly constrained by planning overlays. Flood mapping covers the suburb and none of it falls within a mapped flood overlay, and 60% is flagged bushfire-prone. There are 54 heritage-listed sites on record, and the dominant land-use zone is Community Facilities. The median lot measures about 524 m² across 713 parcels.

Who lives in Bruce

Census 2021 figures published by the ABS for the Bruce suburb boundary itself, not a wider region.

Population
7,520
usual residents, 2021
Median age
29
years
Median household income
$2,266
per week, Belconnen suburb typical $2,331
Median rent
$430
per week, Belconnen suburb typical $438
Median mortgage
$1,733
per month
Household size
2.3
people, average

Socio-economic standing

ABS SEIFA 2021 ranks every Australian suburb. Decile 1 is the most disadvantaged tenth of the country, decile 10 the least.

Advantage and disadvantage (IRSAD) Decile 10
most disadvantagedleast disadvantaged

Score 1117, and decile 8 within the Australian Capital Territory. The national average is 1000.

Relative disadvantage (IRSD) Decile 10
most disadvantagedleast disadvantaged

Age profile

Share of Bruce's 7,520 residents in each ABS age band.

0-4 3.9%
5-14 6.6%
15-19 7.5%
20-24 17.8%
25-34 26.2%
35-44 12.9%
45-54 7.6%
55-64 6.3%
65-74 5.8%
75-84 3.5%
85+ 1.8%

Population trend, 2001 to 2025

Estimated resident population of Bruce, the wider ABS statistical area containing Bruce. There is no annual population series published at suburb level, so this describes the surrounding area rather than Bruce itself.

2,837 in 2001 to 8,119 in 2025, up 186%.

Source: ABS Census 2021 and SEIFA 2021 (Suburbs and Localities), Regional Population (SA2), CC BY 4.0. Small counts are randomly adjusted by the ABS.

Bruce data sources and coverage

“Not mapped” means we hold no source layer for this suburb - never an all-clear.

DatasetCoveragePublisher
Flood mappingMappedthe ACT Territory Plan and ACT Government spatial data
Bushfire-prone mappingMappedthe ACT Territory Plan and ACT Government spatial data
ZoningMappedthe ACT Territory Plan and ACT Government spatial data
Heritage and environmentMapped where publishedthe ACT Territory Plan and ACT Government spatial data
Aircraft noise contours (ANEF)Not heldthe ACT Territory Plan and ACT Government spatial data, Defence
Observed flight pathsObservedadsb.lol, under the Open Database License
DemographicsAvailableAustralian Bureau of Statistics (2021 Census and SEIFA)

Profile last materially updated 14 November 2026. See the methodology and full source list. Source data changes over time and critical decisions should be checked with the responsible authority.

Put this suburb's snapshot on your website (free)

Real estate agents, community groups and local sites can show a small Bruce card with flood, bushfire, main zone and soil reactivity. Copy this code into your page:

Preview the card or pick another suburb.

Check a specific Bruce address

See exactly which overlays touch a single property - the interactive map is free. Need it on paper? A full planning PDF is just $9.

See what's in the $9 report →

Aircraft have been seen below 3,000 ft over about 4% of Bruce. The report's Aircraft Overflight page narrows that to the address itself: how many aircraft a day, how low, and at what heights.

Published flood models are held over parts of Bruce. The free check tells you whether one reaches an address; where it does, a Flood Model Report is +$9 with the planning report.

Bruce planning - frequently asked

Is Bruce flood-prone?

Flood mapping covers Bruce and none of the suburb falls within a mapped flood overlay (the district-wide suburb average is 3%). Published flood models are held over parts of Bruce; the free check on the Flood Model Report page says whether one reaches a given address.

Is Bruce bushfire-prone?

Around 60% of Bruce is mapped as bushfire-prone, compared with a Belconnen average of 26%.

Is Bruce under a flight path?

Aircraft were observed below 3,000 ft over about 4% of Bruce, and over about 100% at any altitude up to 10,000 ft, in the period sampled (4 Sep 2026 to 14 Nov 2026). The lowest measured aircraft was at 2,500 ft, with an average of 4,500 ft. At the busiest point in the suburb about 2 aircraft a day were recorded passing over one 500 m square. Traffic is sampled rather than watched continuously and flight paths change with runway use, weather and season; the ANEF contour is the planning instrument.

What is the zoning in Bruce?

The dominant planning zone in Bruce is Community Facilities, though the suburb also includes Designated and Hills, Ridges and Buffer Areas.

Does Bruce have heritage-listed places?

Bruce has 54 heritage-listed places on record.

What is the typical lot size in Bruce?

Across 713 surveyed parcels in Bruce, the median lot size is about 524 m². There are also 505 registered easements mapped in the suburb.

Does Bruce have a train station?

There is no train station inside Bruce itself. The suburb is served by 36 bus stops.

What is the population of Bruce?

At the 2021 Census Bruce had 7,520 usual residents, with a median age of 29 and an average household size of 2.3 people. The wider Bruce statistical area, which contains Bruce, went from 2,837 people in 2001 to 8,119 in 2025, up 186%.

Is Bruce an advantaged suburb?

On the ABS SEIFA 2021 index of relative socio-economic advantage and disadvantage (IRSAD), Bruce scores 1117 and sits in decile 10 of 10 nationally and decile 8 within the Australian Capital Territory (decile 1 is the most disadvantaged tenth, decile 10 the least).

What is the median household income in Bruce?

Median household income in Bruce was $2,266 a week at the 2021 Census, against $2,331 for the typical suburb in Belconnen. Median rent was $430 a week and the median mortgage repayment $1,733 a month.

Compare nearby suburbs

Nearby suburbDistanceFlood mappedBushfire-prone
Aranda 1.7 km 0% 44%
O'Connor
Canberra Central
2.2 km 3% 41%
Lawson 2.3 km 13% 92%
Belconnen 2.6 km 22% 15%
Macquarie 2.6 km 0% 0%
Kaleen 2.7 km <1% 34%
Lyneham
Canberra Central
2.9 km 5% 23%
Cook 2.9 km 0% 15%
Mckellar 3.6 km 4% 7%
Turner
Canberra Central
3.7 km 3% 0%

See all Belconnen suburb profiles →