Areas / Brimbank / Calder Park

Calder Park flood map & planning overlays

Calder Park is 91% inside aircraft noise contours, 2nd in Victoria.

A planning-constraint profile of Calder Park (Brimbank, VIC) - 2.74 km², mapped from live council and state overlay data. This suburb is highly constrained.
Profile updated 24 October 2026.

Elevation hillshade with street names, clipped to Calder Park's boundary, with the flood, bushfire and environmental overlays drawn on top. Amber hatching is the published aircraft noise (ANEF) contour. Magenta is where aircraft were observed in the sampled period, brightest below 3,000 ft.

Nearby suburbs, nearest first

Aircraft noise and flight paths over Calder Park

The ANEF contour is a published planning forecast and observed overflight is what a sampled tracking feed recorded - neither describes any individual property.

Inside an aircraft noise contour

91%

91% of the suburb's land sits inside a published ANEF or airport-environs contour. Contours vary street by street, so whether a particular lot is inside one needs a property-level check.

Highest contour present

ANEF 25

Under AS 2021, land between ANEF 25 and 30 is generally unacceptable for new houses; 20 to 25 is conditionally acceptable with noise attenuation. The contour is a forecast, not a measurement at any one house.

Contours held

  • Victorian Airport Environs Overlay
  • vic_melbourne_airport_anef_20
  • vic_melbourne_airport_anef_25

Observed overflight - sampled 4 Sep to 24 Oct 2026

Under observed aircraft
72%
of the suburb, at or below 10,000 ft
Below 3,000 ft
28%
of the suburb's area
Lowest measured
1,500 ft
averaging 7,000 ft
Busiest square
~22 a day
±17%
typical observed square 8 a day

Night movements: observed, lowest 2,500 ft - night is sampled as often as day, but night traffic is light, so this is a floor and no rate can be put on it.

How this is measured

Traffic is sampled rather than watched continuously, so every figure is a floor: aircraft not captured between samples are not represented. Rates are per 500 m square - the busiest square in the suburb, not a count of flights over the suburb - and a square is only rated where enough traffic was seen to measure it. Altitudes are above mean sea level. Flight paths change with runway use, weather, season and airspace design. This is a record of observed traffic; it is not a noise contour and not a planning control.

Calder Park at a glance

Parcels 13 Median lot 77,725 m² Mapped easements 6

How Calder Park is zoned

Special Use Zone (SUZ1) 48%
Industrial 3 Zone (IN3Z) 38%
Transport Zone (TRZ2) 6%
Green Wedge Zone (GWZ) 3%
Transport Zone (TRZ1) 3%
Public Use Zone (PUZ1) 1%

Selling in Calder Park? The zoning and planning overlays on this page are the controls a Section 32 vendor statement discloses.

Across its 2.74 km², Calder Park is highly constrained by planning overlays. About 3% of the suburb sits within a mapped flood overlay, and 47% is flagged bushfire-prone. There are 2 heritage-listed sites on record, and the dominant land-use zone is Special Use Zone (SUZ1). The median lot measures about 77,725 m² across 13 parcels.

Calder Park data sources and coverage

“Not mapped” means we hold no source layer for this suburb - never an all-clear.

DatasetCoveragePublisher
Flood mappingMappedVicmap Planning and Victorian Government spatial services
Bushfire-prone mappingMappedVicmap Planning and Victorian Government spatial services
ZoningMappedVicmap Planning and Victorian Government spatial services
Heritage and environmentMapped where publishedVicmap Planning and Victorian Government spatial services
Aircraft noise contours (ANEF)Inside a held contourVicmap Planning and Victorian Government spatial services, Defence
Observed flight pathsObservedadsb.lol, under the Open Database License
DemographicsNot availableAustralian Bureau of Statistics (2021 Census and SEIFA)

Profile last materially updated 24 October 2026. See the methodology and full source list. Source data changes over time and critical decisions should be checked with the responsible authority.

Check a specific Calder Park address

See exactly which overlays touch a single property - the interactive map is free. Need it on paper? A full planning PDF is just $9.

See what's in the $9 report →

Aircraft have been seen below 3,000 ft over about 28% of Calder Park. The report's Aircraft Overflight page narrows that to the address itself: how many aircraft a day, how low, and at what heights.

Building or pricing a slab? The $119 geotechnical desktop report covers geology, soils, bores and the indicative soil reactivity range to expect for a Calder Park lot.

Calder Park planning - frequently asked

Is Calder Park flood-prone?

About 3% of Calder Park falls within a mapped flood overlay, against the council-wide suburb average of 6%.

Is Calder Park bushfire-prone?

Around 47% of Calder Park is mapped as bushfire-prone, compared with a Brimbank average of 15%.

Is Calder Park affected by aircraft noise?

About 91% of Calder Park sits inside a published aircraft noise contour, and the highest contour present is ANEF 25 - under AS 2021, land above ANEF 25 is generally considered unacceptable for new houses, and 20-25 conditionally acceptable with noise attenuation. ANEF contours are forecasts published per airport and used to control noise-sensitive development; they are not a measurement at any one house, and a property can sit under a flight path and outside every contour.

Is Calder Park under a flight path?

Aircraft were observed below 3,000 ft over about 28% of Calder Park, and over about 72% at any altitude up to 10,000 ft, in the period sampled (4 Sep 2026 to 24 Oct 2026). The lowest measured aircraft was at 1,500 ft, with an average of 7,000 ft. At the busiest point in the suburb about 22 aircraft a day were recorded passing over one 500 m square. Traffic is sampled rather than watched continuously and flight paths change with runway use, weather and season; the ANEF contour is the planning instrument.

What is the zoning in Calder Park?

The dominant planning zone in Calder Park is Special Use Zone (SUZ1), though the suburb also includes Industrial 3 Zone (IN3Z) and Transport Zone (TRZ2).

Does Calder Park have heritage-listed places?

Calder Park has 2 heritage-listed places on record.

What is the typical lot size in Calder Park?

Across 13 surveyed parcels in Calder Park, the median lot size is about 77,725 m². There are also 6 registered easements mapped in the suburb.

Compare nearby suburbs

Nearby suburbDistanceFlood mappedBushfire-prone
Sydenham 2.3 km 3% <1%
Hillside (Greater Melbourne)
Melton
2.5 km <1% 17%
Keilor North 2.8 km 9% 100%
Taylors Lakes 3.0 km 8% 3%
Keilor Lodge 4.1 km 3% 2%
Taylors Hill
Melton
4.5 km 1% 0%
Delahey 5.0 km 2% 0%
Fraser Rise
Melton
5.4 km <1% 42%
Plumpton
Melton
5.9 km 1% 100%
Bulla
Hume
6.2 km 1% 98%

See all Brimbank suburb profiles →