Can I subdivide my block?
The first test in NSW is lot area against the minimum lot size in the council's LEP. Here is how to run it, and what it leaves out.
Step 1: find the minimum lot size
Every NSW council's Local Environmental Plan sets a minimum lot size for subdivision, usually in clause 4.1, and maps it on a Lot Size Map. The figure changes from street to street: 450 m² in one suburb, 700 m² in the next, 2 ha or 40 ha on rural land. Some land has no minimum at all.
Step 2: compare it with your lot area
Divide your lot area by the minimum. Under 2 and the block cannot be split into two Torrens title lots that both meet the minimum. At 2 or more, it passes the area test, and the whole number tells you the most lots that area alone allows.
Use the area on your title plan where you can. Mapped areas differ a little from registered ones, so a block within about 1% of a multiple is decided by the plan, not by a map.
Step 3: what the area test does not tell you
- Frontage and access - a minimum lot width or street frontage, usually in the council's Development Control Plan, and road access for each lot. Some LEPs leave a battle-axe handle out of the lot area.
- Servicing - water, sewer, stormwater, power and telecommunications to each new lot, and the cost of connecting them.
- Title - easements, covenants and restrictions, and whether the land is part of a strata or community scheme.
- Layout - lot shape, slope, setbacks, the existing house and trees.
- Other clauses - lot averaging, dual occupancy subdivision rules, clause 4.6 variations, and hazards such as flood and bushfire mapping.
Subdivision in NSW needs development consent unless it falls in the limited exempt or complying development cases, so the council has the final say on all of these.
The lot size test in the Property Report
For NSW addresses, the LayeredGeo Property Report runs the area test for you. It reads the minimum lot size mapped over the lot, measures the lot from the NSW cadastre, and sets out the lot area, the minimum, how many times the lot holds it, and the list of things the test does not check. It sits next to the zoning, flood, bushfire, heritage, easement and services pages for the same lot.
It is a fact check against the mapped standard. It does not draw a subdivision layout and is not advice that one would be approved. Talk to the council or a registered surveyor before you commit.
Common questions
How do I find the minimum lot size for my block in NSW?
It is set by the council's Local Environmental Plan (LEP), usually in clause 4.1, and mapped on the LEP's Lot Size Map. You can look it up on the NSW Planning Portal's Spatial Viewer, and it is printed against the lot in a LayeredGeo Property Report wherever the map covers it.
If my block is twice the minimum lot size, can I subdivide it?
It passes the first test, but not the only one. Subdivision in NSW needs development consent, and the council also looks at frontage and lot width, access to a road, water and sewer connections, easements and covenants on the title, slope and the existing house. A block twice the minimum can still fail on any of those.
Does the minimum lot size apply to strata subdivision?
In most NSW LEPs, no. Clause 4.1 commonly says it does not apply to subdivision by strata plan, so a duplex or townhouses can be strata titled on a lot that could not be split into Torrens title lots. Check the wording of your own LEP.
Is a battle-axe handle counted in the lot area?
Some LEPs leave the access handle of a battle-axe lot out of the area tested against the minimum, so the rear lot has to meet the minimum without it. Others count it. The clause is in your council's LEP.
Can the minimum lot size be varied?
Sometimes, under clause 4.6 of the LEP, with a written case that the standard is unreasonable or unnecessary for the site. It is not automatic, and many LEPs rule it out for subdivision in rural and large lot residential zones.