Building and pest inspection cost in 2026, and what it does not check

A building and pest inspection on a typical three-bedroom house costs about $550 to $750 in 2026, and most combined quotes fall between $450 and $900. Units sit at the low end, while older, larger and multi-storey homes sit at the top. A pest-only or building-only inspection usually costs $300 to $550.

The inspection looks at the house and for timber pests. It does not look at the land the house sits on: flood, zoning, overlays, easements and the ground are outside its scope. That gap is covered at the end of this guide.

How much does a building and pest inspection cost?

RACV's 2026 guide gives the clearest published ranges. They are Victorian, but quotes in the other mainland capitals land in much the same band:

Property Combined building and pest (2026)
Apartment or unit, 1-2 bedrooms $450 - $600
Average house, 3 bedrooms, 2 bathrooms $550 - $750
Larger family home, 5 bedrooms $650 - $850
Multi-storey home $650 - $900+
Older property $700 - $900+

Source: RACV, building and pest inspection cost guide, October 2026. RACV puts a building-only inspection in Melbourne at around $300 to $550 and a pest-only inspection at around $300 to $550.

Marketplace guides quote lower figures. Airtasker's cost guide (formerly Oneflare) gives about $350 to $490 for a building inspection on a three-bedroom home and about $500 for building and pest together, but the page was last updated in December 2023. Treat it as a floor, not a 2026 price.

Building and pest inspection cost by state

No regulator publishes a state-by-state price. What changes between states is mainly the rules for who can inspect and how far the inspector travels:

  • Queensland. Building inspectors and timber pest inspectors must hold a QBCC licence for pre-purchase work. Termite pressure is high across the south-east and north, so the pest half of the job matters more than in cooler states.
  • New South Wales. Inner Sydney houses tend to be quoted at the top of the range, mostly because of age and access.
  • Victoria. The RACV ranges above apply. Regional Victoria can cost more because of travel.
  • South Australia, Western Australia and Tasmania. Quotes are usually similar or a little lower than the eastern capitals, with travel charges added outside the metro area.

The things that move a quote are the same everywhere: size, number of storeys, age, extensions and outbuildings, how hard the roof space and subfloor are to reach, and travel. A re-inspection or a specialist report (structural engineer, plumber, electrician, asbestos) is extra.

What does a building and pest inspection check?

A pre-purchase building inspection is a visual inspection of the accessible parts of the house, usually done to Australian Standard AS 4349.1. The inspector looks for major and minor defects and safety hazards in the building elements: roof, roof space, walls, floors, subfloor, wet areas, windows and doors, and the outbuildings on the lot. Consumer Affairs Victoria says the written report should list the faults, whether they can be repaired and roughly what repairs would cost, and flag unsafe or unauthorised renovations or extensions.

A timber pest inspection, usually to AS 4349.3, looks for termites, borers and wood decay, and for conditions that make an attack more likely, such as timber in contact with soil, poor drainage or high moisture under the floor.

What does a building and pest inspection not check?

The standard limits the job to what the inspector can see and reach on the day. Areas behind furniture, under floor coverings, inside walls or in a roof space with no safe access are excluded, and the report will say so. RACV notes that an inspection is not a guarantee that the property is free of defects.

The bigger gap is the land. A building and pest inspection does not check:

  • Flood. Whether the lot sits in a flood overlay, how deep a modelled flood would be, or whether the council sets a minimum floor level.
  • Zoning and overlays. What the land is zoned, and whether bushfire, heritage, character, landslide or environmental overlays apply.
  • Easements and pipes. Registered easements on the title, and sewer or stormwater mains crossing the lot.
  • The ground. Slope, fill and how reactive the clay is. The inspector may note cracking in the house, but not why the ground moves.
  • Approvals. Whether past building work was approved. The inspector can only say it looks unauthorised.

Queensland's Form 2 seller disclosure statement says on its first page that it does not cover flooding, structural soundness or pest infestation either, so in Queensland neither document answers the flood question. See what Form 2 leaves out.

Is a building and pest inspection worth it?

For a house, yes. It is the only check that looks at the condition of the building, and a few hundred dollars is small against the cost of a failed roof, rising damp or an active termite nest. Consumer Affairs Victoria advises buyers to use an inspector with professional indemnity insurance and to be wary of reports supplied by the agent or seller. For a unit, the inspection is usually limited to the unit itself, not the common property, so the body corporate or owners corporation records matter as much.

Make the contract subject to a satisfactory building and pest report where you can, and book the inspection early in the cooling-off period if you cannot.

Questions to ask before you book

  • Which standard do you inspect to, AS 4349.1 for building and AS 4349.3 for timber pests?
  • Are you licensed (QBCC in Queensland) and insured for professional indemnity?
  • Will you inspect the roof space and subfloor, and what happens if access is blocked?
  • When will I get the written report, and will you talk me through it by phone?
  • Is a re-inspection before settlement included, or extra?

Checking the land as well as the house

The inspector covers the building. The land checks are separate and mostly come from public mapping: the council flood map or flood report, the planning scheme map for zoning and overlays, the title for easements, the water authority's maps for sewer mains, and elevation data for slope.

LayeredGeo's Property Report puts the zoning, flood, bushfire, heritage and character overlays, registered easements and the mapped sewer and stormwater pipes for one address into a single $9 PDF. A free map preview shows what is mapped before you pay. It is not a building inspection, a council certificate or a title search, so it sits alongside the building and pest report rather than replacing it. For the full list of checks, see which property report to get before buying, or pop in an address to see what is mapped over the lot.

Common questions

How much does a building and pest inspection cost?

About $550 to $750 for a typical three-bedroom house in 2026, and $450 to $900+ across most properties. Units are cheaper, and older, larger and multi-storey homes cost more (RACV, October 2026).

How much is a pest inspection on its own?

RACV puts a pest-only inspection at around $300 to $550 in 2026, about the same as a building-only inspection.

Does a building and pest inspection check for flooding?

No. It is a visual inspection of the house and for timber pests. Flood, zoning, overlays, easements and the ground are outside its scope, so check them from the council flood map, the planning scheme and the title.

Who pays for the building and pest inspection?

The buyer usually books and pays for it. Consumer Affairs Victoria advises being wary of an inspection report supplied by the agent or seller.

What the inspector does not look at

The land under the house, for $9

Zoning, flood, bushfire, heritage and character overlays, registered easements and the mapped sewer and stormwater pipes for one address, in one PDF. The map preview is free and the PDF is $9.

Check an address → See a sample report

About this article. Published by LayeredGeo and written from the published research cited in the Sources section above. It is general information about how property and ground conditions are assessed in Australia, not engineering, planning, legal or financial advice, and it is not specific to any property. Check anything that matters against the source dataset or a suitably qualified professional before you rely on it. If you spot something wrong, tell us at hello@layeredgeo.com.au and we will fix it.

← All articles