Toowoomba interactive mapping: planning scheme and flood maps
Toowoomba Regional Council's interactive mapping is a set of free online maps, reached from the council's Online mapping page. Two of them matter when you are checking a property: the planning scheme map at maps.tr.qld.gov.au/WAB/PlanningScheme, which shows the zone and overlays, and the TRC Flood Risk Portal at maps.tr.qld.gov.au/WAB/FloorLevelPortal, which shows the flood risk rating for a lot. Search the address in each, select the property, and read what applies to it.
Try it on your own address - free map of every overlay, then a $9 Property Report.
LayeredGeo is not part of Toowoomba Regional Council or the Queensland Government. The council's maps are free council tools and the right place to start for a Toowoomba, Highfields, Oakey or Pittsworth property. LayeredGeo's Property Report is a separate $9 PDF that puts the zone and the flood, bushfire and heritage overlays for one address in one document, with a plain-English note for each.
Which planning scheme applies
The Toowoomba Regional Planning Scheme is the scheme in force. The council's website says version 29 took effect on 21 July 2026.
A replacement is on the way. The council is drafting a new planning scheme, and its project page lists public consultation as anticipated for March 2027 and adoption in November 2027, with the draft due to go to a council meeting on 17 November 2026. Until a new scheme is adopted, the current one decides what applies to a property. If you are buying with a plan to develop later, read the project page so you know what may change.
LayeredGeo Property Reports
Check this for any address
Zoning, flood, bushfire and every other planning overlay that applies to a lot - mapped and explained in a $9 report. No account needed.
The four council maps
The Online mapping page links to separate maps, each for a different job:
- Planning scheme. Zones and overlays under the Toowoomba Regional Planning Scheme.
- Flood risk. The TRC Flood Risk Portal, which gives a flood risk rating for each property.
- Property. General property details.
- Historical imagery. Older aerial photographs, useful for seeing what was on the land before.
How to find a property
- Open the planning scheme map from the council's Online mapping page.
- Search for the property by its street address and select it. If the search does not offer a match, zoom the map to the land.
- Read the zone first, then the overlays. Turn layers on and off to see where each one sits on the lot, and look at the neighbouring lots as well.
- Open the Flood Risk Portal separately. The council's instructions are to accept the disclaimer, zoom or search to the location, then click the property. The flood areas can take a few seconds to draw.
The council does not publish a detailed user guide for the maps, so follow the on-screen prompts where the layout differs. Its help route is the Contact us form on the council website.
What the map shows
Zones. Every property has a zone, and the council notes that some larger properties have more than one. The zones the council lists are Residential, Rural residential, Rural, Centre, Industry (low, medium and high impact), Township, Mixed use, Extractive industry, Community facilities, Emerging communities and Limited development (constrained land). The zone tells you what the land can be used for and roughly what can be built.
Overlays. Overlays are mapped areas where extra planning rules apply. The council lists:
- Flood hazard. Covered in the next section.
- Bushfire hazard. Affects building requirements on and near bushland, and is worth checking on any rural residential block.
- Landslide hazard. Flags steeper land where slope stability and earthworks need extra care.
- Heritage and neighbourhood character. These overlays can limit demolition of an older house and change what an extension has to look like. Our guide to checking a heritage listing before you buy explains what a listing can stop you doing.
- Environmental significance, scenic amenity and water resource catchment. These can limit clearing and where a building may sit.
- Agricultural land and extractive resources. Mostly a rural matter, but a quarry resource area near a block is worth knowing about.
- Airport environs and regional infrastructure corridors and substations. These show where aircraft operations or major infrastructure affect what can be built.
How Toowoomba maps flood
The flood hazard overlay is recent. Parts of the region flooded severely in December 2010 and January 2011, with loss of life. The council then ran flood studies for 34 urban areas and the Condamine River catchment, and added the Flood Hazard Overlay to the planning scheme through Amendment No. 17, which took effect on 21 August 2020.
The overlay does not draw one flood line. It gives each affected area a risk rating:
| Rating | What the council calls it |
|---|---|
| FR1 | Low flood risk |
| FR2 | Medium flood risk |
| FR3 | High flood risk |
| FR4 | Extreme flood risk |
Other labels appear as well: Balanced (mixed), Overland flow (low), Overland flow (high), Vulnerable use restriction area and Flood island. The council says the Balanced (mixed) label relates to a flood with a one in 100 chance, and that the Vulnerable use restriction area covers the probable maximum flood, the largest flood that could conceivably happen.
The rating affects what you build. The council's flood page describes minimum floor heights above the defined flood event of 300 mm in low risk areas and 500 mm in medium risk areas. The Flood Risk Portal also shows "proposed planning responses" for a property, which the council describes as proposed, not adopted.
The council publishes the studies behind the mapping, including the Gowrie Creek Flood Study (2015), the Condamine Flood Study (2014), the TRC-Wide Regional Flood Study (2017) and about 25 township studies, on its Flood Studies page. Our Toowoomba flood map by suburb page compares the mapped flood share of each suburb in the region.
What it does not tell you
- Flooding outside the mapped areas. The council says: "It's always possible that flooding could happen in places not shown on the current maps." It also notes that areas between towns have not been studied in detail and can still flood.
- Whether a house floods. A risk rating describes the land. In the council's words, "Whether water gets inside a building depends on things like slope, drainage, and floor height." Our guide to reading a flood overlay versus actual flood risk explains the difference.
- It is not a council certificate. The maps are a guide. For a formal answer the council sells planning and development certificates in three levels: Limited (5 days), Standard (10 days) and Full, which includes an inspection (30 days). The property searches page links to the current fee for each.
- Ground conditions. Soil reactivity, geology, fill and groundwater are not planning layers, yet they drive footing design and slab cost.
- Title matters. Easements, covenants and other interests come from the title, not the planning map.
- Development next door. Development applications are searched separately, in the council's Development.i tool, by address, application number or on a map.
Putting the planning layers in one PDF
The council's maps are the official source, so start there. If you are comparing several properties, or want the planning layers plus other site data together, LayeredGeo's Property Report puts zoning, flood, bushfire, heritage, vegetation and environmental overlays for an address into a single PDF, with a map and a plain-English note for each, alongside contours, registered easements and the water, sewer and stormwater mains the utilities publish. The map preview is free and the PDF is $9. Pop in your address or check out a sample report.
If you are building, a separate geotechnical desktop study covers the geology, soils, indicative soil reactivity range and groundwater for the address. It does not replace a site investigation, which is what decides the site classification.
Common questions
What is Toowoomba interactive mapping? It is Toowoomba Regional Council's free online mapping, linked from the Online mapping page on the council website. It includes a planning scheme map for zones and overlays, the TRC Flood Risk Portal, a property map and historical imagery.
How do I check if a Toowoomba property is in a flood area? Open the TRC Flood Risk Portal, accept the disclaimer, search the address and click the property. It shows the flood risk rating, from FR1 low to FR4 extreme, along with overland flow areas. The same ratings sit in the Flood hazard overlay of the planning scheme map.
What do FR1, FR2, FR3 and FR4 mean on the Toowoomba flood map? They are the council's flood risk ratings: FR1 low, FR2 medium, FR3 high and FR4 extreme. The rating sets the planning rules for new building, including minimum floor heights in the lower risk areas.
Is Toowoomba getting a new planning scheme? Yes. The council is drafting one. Its project page lists public consultation as anticipated for March 2027 and adoption in November 2027. Version 29 of the current Toowoomba Regional Planning Scheme, in effect from 21 July 2026, applies until then.
LayeredGeo's Property Report pulls together public planning and site data for property due diligence across Queensland, New South Wales, Victoria, South Australia, the ACT and Tasmania, so you can understand a place before you commit.
Common questions
What is Toowoomba interactive mapping?
It is Toowoomba Regional Council's free online mapping, linked from the Online mapping page on the council website. It includes a planning scheme map for zones and overlays, the TRC Flood Risk Portal, a property map and historical imagery.
How do I check if a Toowoomba property is in a flood area?
Open the TRC Flood Risk Portal, accept the disclaimer, search the address and click the property. It shows the flood risk rating, from FR1 low to FR4 extreme, along with overland flow areas. The same ratings sit in the Flood hazard overlay of the planning scheme map.
What do FR1, FR2, FR3 and FR4 mean on the Toowoomba flood map?
They are the council's flood risk ratings: FR1 low, FR2 medium, FR3 high and FR4 extreme. The rating sets the planning rules for new building, including minimum floor heights in the lower risk areas.
Is Toowoomba getting a new planning scheme?
Yes. The council is drafting one. Its project page lists public consultation as anticipated for March 2027 and adoption in November 2027. Version 29 of the current Toowoomba Regional Planning Scheme, in effect from 21 July 2026, applies until then.
LayeredGeo Property Reports
Check this for any address
Zoning, flood, bushfire and every other planning overlay that applies to a lot - mapped and explained in a $9 report. No account needed.
About this article. Published by LayeredGeo and written from the published research cited in the Sources section above. It is general information about how property and ground conditions are assessed in Australia, not engineering, planning, legal or financial advice, and it is not specific to any property. Check anything that matters against the source dataset or a suitably qualified professional before you rely on it. If you spot something wrong, tell us at hello@layeredgeo.com.au and we will fix it.
Related articles
Old aerial photos of your property: QImagery, NSW and national archives
Find free historical aerial photos of an Australian property back to the 1930s: QImagery in Queensland, the NSW Historical Imagery Viewer and the Commonwealth archive.
16 November 2026Gympie interactive mapping: zones, overlays and flood levels
Gympie interactive mapping guide: find a property's zone, overlays and flood level on the council's online map, and what the new planning scheme changes.
15 November 2026ACTmapi or a Property Report: checking an ACT block
Comparing ACTmapi, the ACT Territory Plan viewer and a Property Report for due diligence on a Canberra block: zone, overlays, flood and lease.